缺你不可:开机显示Verifying DMI Pool Data...........Error loading operating system是什么意识？

重动时错误加载!!!

参考资料::::::
maxtor官方：Suggestions to Resolve the Condition:
1)Apply power to the computer. 开机（不插硬盘）。
2)Access the system BIOS. Set the drive type as None or Not Installed. Load BIOS Defaults .Load SETUP Defaults .在BIOS里，把硬盘设为NONE。
3)Save the BIOS changes and reboot the PC to a System Boot Diskette. 用启动盘重启机。
4)Shut down the PC after the memory count is displayed. 检测完内存后关机。
5)Reconnect the power and interface cables to the hard drive. 重新插上硬盘电源和数据线。
6)Access the System BIOS. 进入BIOS。
7)Auto-Detect the hard drive. Ensure that the LBA Mode option is enabled. 设为自动检测硬盘。确认LBA模式无误。
8)Save the BIOS changes and boot the PC with a System Diskette. 软盘启动。
9)Partition and format the hard drive via the operating system. 分区格式化。
10)Reboot the system. On bootup, the screen should read: 重启机，显示如下：
Verifying DMI Pool Data Update Successful
11)The system should continue booting normally. 正常。

Other Possible Solutions:

1)Apply power to the computer. 开机。
2)Access the System BIOS. 进入BIOS。
3)Disable both the Internal and External CPU Cache. These features are located in either the "BIOS Features" or "Advanced Settings" options of the BIOS Setup. NOTE: Consult the System or Motherboard User\'s Manual for exact location of the Internal and External CPU Cache settings. 参考系统或主板说明，在"BIOS Features"或 "Advanced Settings"选项里，将内/外部CPU Cache设置为不可用。
4)Save the BIOS changes and reboot the PC to a System Boot Diskette. On bootup, the screen should read: 重启机，显示如下：
Verifying DMI Pool Data Update Successful
The system should continue booting normally. 可以正常引导。
7)After the system successfully boots, re-start the PC and access the system BIOS.
Enable the External CPU Cache. This feature is located in the "BIOS Features" or "Advanced Settings".
NOTE: Consult the System or Motherboard User\'s Manual for exact location of the External CPU Cache setting.成功引导后，重启机，在BIOS里将CPU的两个项恢复为enable。
! WARNING ! User\'s MUST re-enable this feature for optimal system performance. 该步骤必须执行。
8)Save the BIOS changes and reboot the PC to a System Boot Diskette. On bootup, the screen should read:
Verifying DMI Pool Data
Update Successful
The system should continue booting normally.
再重启，可正常使用。

NOTE: If the aforementioned suggestions fail to resolve the issue, contact the system or motherboard manufacturer to:
Remove the "Clear CMOS" Jumper and reset the system BIOS
Obtain a Flash BIOS Upgrade

同意此人意见！